How to Configure Your Mini WiFi Extender
Follow these simple steps and your internet will reach every corner of your home!
Plug into a power socket
For AP or Repeater mode, place the extender in a room where your existing WiFi signal still reaches but feels weak. For Router mode, connect the built-in LAN port directly to your modem instead.
Connect it to your WiFi
Connect to the extender's own WiFi from your phone or laptop and a setup page will open automatically. If it does not open, just type zrlogin.cn in your browser and you are good to go — no IP address needed! During setup, simply choose the mode you want to run it in.
Wait a few seconds
The extender will save your settings and create a new WiFi network. This only takes a few seconds. The lights on the device will tell you when it is ready.
Enjoy better WiFi everywhere!
Connect your phone, laptop, or TV to the new extended network and enjoy strong WiFi in areas that had weak or no signal before.
AP Mode
Connect the device to your router with the LAN cable to create a fresh WiFi access point in a room with no signal at all — great for basements or far corners of the house.
Repeater Mode
No cable needed. The extender wirelessly picks up your existing router's signal and rebroadcasts it further, extending your current WiFi network.
Router Mode
Plug the LAN port straight into your modem and the extender works as its own standalone router, creating a brand new WiFi network from scratch.
You do not need to type any IP address anymore. Just open any browser and go to zrlogin.cn and it will take you straight to the setup page. Simple as that!
Yes! In Repeater or AP mode you can set it up wirelessly as long as your main router's signal reaches it. Only Router mode needs the LAN cable connected to your modem.
When you order the product, you can choose to add a LAN cable during checkout. It is optional, so you decide if you want it or not.
Yes, you can open and check the box before you accept the delivery. Make sure everything looks good and nothing is broken before signing.
Yes, if the device is still not working after you have followed all the reset steps, you can return it. Just contact our customer support team and they will help you out.
Use Repeater mode if you just want to extend your current WiFi wirelessly. Use AP mode if you're running a cable to a spot with zero signal. Use Router mode if you want the extender to act as your main router, connected directly to the modem.
Being a compact mini device, it typically covers an extra 500 to 800 square feet depending on walls and furniture. For best results, place it halfway between your router and the spot with weak signal.
This mini extender can handle up to 10 to 15 devices at the same time. If too many devices connect together, the speed may go a little slower for everyone.
It might drop a tiny bit because the extender first receives the signal and then sends it again. But with up to 300 Mbps capability, you will have more than enough speed for videos, browsing, and calls.
No! Once you set it up the first time, it remembers your network and your chosen mode. Just plug it in and after a few seconds it will connect on its own automatically.
Try moving it a little closer to your router so it gets a stronger signal. Also keep it away from microwaves or cordless phones as they can cause interference. If it still keeps disconnecting, reset the device using the small pinhole button on the side — insert a pin or SIM-eject tool and press and hold for 8-10 seconds until the lights blink, then set it up again from the beginning.
